You are purchasing one 50k BTU unit heater WITH on off on
switch. Perfect for garages, shops, greenhouses etc. They can also
be hooked up to a "cold/chilled" water source to provide cool air as
well! Can be mounted or set on shelf, bench, or floor.
Ports on the side as they should be, so you don't have
clearance issues if you want to hang them up close to the ceiling. Also, if you
plumb the port closest to the fan as your hot supply, this will allow you to
preheat and then super-heat the air as it passes through the water coil. We do
not use a rheostat as these fan motors are not made for that application
and can burn out your motor quickly.
There are TWO yes two warranties
Manufactures warranty: MFG defects - does not include
freezing, rust, or corrosion leaks - shipping not included in warranty
Customer abuse warranty: If you freeze the unit, you
can buy a replacement coil at a discounted rate -shipping not included in
warranty
FACTS / Specs
Unit Heater
- 9 ft. power cord plus 1 ft cord w/plus delivers
optimal, safe AC power through a 14-Gauge heavy-duty cord (this allows you
to choose if you want to use the 2 speed switch or just hard-wire on one
speed.
- replaceable 12x12 water to air coil inside
- 2 speed capable or direct wire up one of the speeds if
you don't want to use the switch
- US standard 1" copper connections
- Includes holes in top and bottom housing for bolts AS
WELL AS mounting holes for for threaded rod for ease of
installation (actual mounting rods and hardware NOT included)
- Dimensions 15 3/4" X 12" X 13 1/2"
(LxWxD (including fan shroud)
- Weight in box 27#
- CFM chart below
SERVICE, SERVICE, SERVICE!!! Even after the purchase!
You can contact us with questions
for our knowledgeable staff!
Heather 920-838-4205
Jake 920-838-1765
